What is the heat installation of the stainless steel metering pump, you know? Don't worry, the hydraulic diaphragm metering pump manufacturer, koyu machinery, will answer your question.

Place your stainless steel metering pump preheating furnace, according to the spinning temperature, set temperature, usually slightly higher than that of spinning temperature, preheating temperature of 10 ℃. Preheating time, according to the pump model, specifications, specification and other requirements, generally set in 8 ~ 24 h.

After preheating to setting the temperature, heat insulation and wait for the machine. Before installation, the stainless steel metering pump removed from the preheating furnace needs to be checked again with a hand plate to check whether the rotation is flexible. If the phenomenon of card death occurs, the cap screw can be loosened for review: the death phenomenon of the card will disappear, and the screw can be adjusted and tightened. The death of the card has not disappeared, it needs to be decomposed. After the review, the pump with the card dead is not installed.

When installing the stainless steel metering pump, the torque wrenches are evenly fastened with torque wrenches according to the operating instructions of the pump. If there is a tension and the phenomenon of card death, the installation screw can be loosened for review: the over-tightening and the card-death phenomenon disappear, indicating that the plane of the connection plane is not good and needs to be further checked. The death of the card has not disappeared and the pump needs to be checked. After the review, the pump with the card dead is not installed.

Precautions: before installing the machine, carefully clean the connection surface of the stainless steel measuring pump and pump board to ensure that there is no foreign matter; Fastening screw must be applied to high temperature anti-sinter grease; After the temperature balance, can be replenished to tighten; The size of the fastening moment must refer to the operating instructions of the stainless steel metering pump. Too small, may result in connection surface leakage; Excessive, may cause pump card to die.